
Configuring IP Exterior Gateway Protocols (BGP and EGP)
3-30
308628-15.0 Rev 00
For example, the following command sequence configures the router to log BGP
warning, fault, and trace messages for open and keepalive packets for a peer
connection, and then disables message logging:
peer/2.2.2.2/2.2.2.4#
debug-control
debug-control/2.2.2.2/2.2.2.4#
log-message-type {warning fault trace}
debug-control/2.2.2.2/2.2.2.4#
log-packet-type {open
keepalive}
debug-control/2.2.2.2/2.2.2.4#
log-packet-type disabled
debug-control/2.2.2.2/2.2.2.4#
back
peer/2.2.2.2/2.2.2.4#
Using Site Manager
To configure BGP event message logging, complete the following steps:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
BGP
. The BGP menu opens.
4. Choose
BGP DEBUG.
The BGP DEBUG Parameters window
opens.
5. Click on
Add
. The NEW BGP DEBUG window opens.
6. Set the following parameters:
• Peer Local/Remote
• Message Level
• Message Trace Switch
Click on
Help
or see the parameter
descriptions beginning on page A-24
.
7. Click on
OK
. You return to the BGP DEBUG
Parameters window.
8. Click on
Apply
, and then click on
Done
. You return to the Configuration Manager
window.
Komentarze do niniejszej Instrukcji