
Configuring IP Exterior Gateway Protocols (BGP and EGP)
A-18
308628-15.0 Rev 00
Parameter: Next Hop Self
Path: Configuration Manager > Protocols > IP > BGP > Peers > BGP Peers
Default: Disable
Options: Enable
|
Disable
Function: Enables or disables the use of third-party advertisements.
Instructions: Specify Enable to send the local peer’s address as the next hop in all
advertisements. Accept the default, Disable, to allow third-party advertisements.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.2.1.40
Parameter: Peer EBGP ECMP Method
Path: Configuration Manager > Protocols > IP > BGP > Peers > BGP Peers
Default: Disabled
Options: Disabled
|
Route Balance
|
Traffic Balance
Function: Configures BGP to use ECMP routes in the routing table for route balancing or
traffic-load balancing.
Instructions: To configure BGP to use ECMP routes for route balancing, set this parameter to
Route Balance. To configure BGP to use ECMP routes for traffic-load
balancing, set this parameter to Traffic Balance.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.2.1.42
Parameter: Tcp Authentication
Path: Configuration Manager > Protocols > IP > BGP > Peers > BGP Peers
Default: None
Options: None
|
MD5
Function: Specifies whether to use MD5 authentication for this connection.
Instructions: Specify MD5 to enable BGP TCP MD5 authentication for this connection. This
also makes Tcp Md5 Key Storage and Tcp Md5 Key parameters accessible.
Accept the default, None, to disable BGP TCP MD5 authentication for this
connection.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.2.1.45
Komentarze do niniejszej Instrukcji