Avaya Troubleshooting Routers Instrukcja Naprawy Pobierz pdf (Strona 227)

Using the Technician Interface to Configure and Run Packet Capture

308656-14.00 Rev 00

B-33

Enter the following commands at the command-line interface of the Sun

workstation:

Issue the following command to start FTP:

FTP

Issue the following command to establish an FTP connection with the

router:

open

<IP_address>

is the IP address of the router.

Example

connect 1.1.1.1

Enter the following command to specify that the file to be transferred is

binary:

mode binary

Enter the following command to retrieve a copy of the file:

get

is the name displayed after you issued the get command in

“Getting the Name of the Packet Capture File

.”

Example

get pcap0400

Enter the following command to terminate FTP:

quit

Using TFTP to Transfer the File

When you use TFTP to get a Packet Capture file, the TFTP software transfers it

from the processor’s memory instead of from the media.

The procedure for using TFTP to transfer a copy of a file to a Sun workstation or

PC depends on the implementation of TFTP on that system. The following

instructions apply to Sun workstations.

If you are using a PC and need instructions for using TFTP, refer to the

documentation for the TCP/IP stack installed on the PC.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 267 268

Brak uwag

Avaya Troubleshooting Routers Instrukcja Naprawy Strona 227