Avaya Troubleshooting Routers Instrukcja Naprawy Pobierz pdf (Strona 213)

Using the Technician Interface to Configure and Run Packet Capture

308656-14.00 Rev 00

B-19

Configuring a Termination Trigger

By default, Packet Capture terminates only when you issue the command to

terminate it. You can change this default so that Packet Capture terminates when

either of the following occurs:

• The Packet Capture file is full.

• It matches a portion of an incoming or outgoing packet to a hexadecimal

number or character string that you specify.

You can issue a command to terminate Packet Capture even if you configure it to

terminate on its own.

If you want Packet Capture to terminate itself and

• You configured Packet Capture to copy incoming packets, enter the following

command:

set wfPktCaptureEntry.12.

<line_no.> <value>

;commit

represents the wfPktCaptureRxTrigger attribute.

• You configured Packet Capture to copy outgoing packets, enter the following

command:

set wfPktCaptureEntry.13.

<line_no.> <value>

;commit

represents the wfPktCaptureTxTrigger attribute.

Enter both commands if you want to change the trigger settings for both incoming

and outgoing packets.

<line_no.>

is the number displayed after you issued the

get

command in “Creating

an Instance of Packet Capture.” To list the current line numbers associated with

Packet Capture, enter the command

list instances wfPktCaptureEntry

1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 267 268

Brak uwag

Avaya Troubleshooting Routers Instrukcja Naprawy Strona 213