
Configuring IP Utilities
1-6 117358-A Rev. A
Configuring IP for Global Protocols
Before you configure TCP, FTP, TFTP, Telnet, NTP, and NetBIOS over IP using
the BCC or Site Manager, you must first start IP on the router.
Using Site Manager
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as an interface to an attached network. For information
and instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
When you have successfully configured the circuit, the Select Protocols window
opens. Proceed as follows:
Using the BCC
To start IP on the router:
1. Configure a physical interface on an available slot/connector.
2. Configure an IP interface on the physical interface.
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select IP.
Then click on OK.
The IP Configuration window opens.
2. Set the following parameters:
• IP Address
• Subnet Mask
• Transmit Bcast Addr
• UnNumbered Assoc Address
Click on Help or see the parameter
descriptions in
Configuring IP Services
.
3. Click on OK. You return to the Configuration Manager
window.
Komentarze do niniejszej Instrukcji