Avaya Configuring IP, ARP, RIP, and OSPF Services Instrukcja Użytkownika Pobierz pdf (Strona 156)

100

101

Configuring IP, ARP, RIP, and OSPF Services

5-26

117356-E Rev 00

For example, the following command sets the state to disabled for RIP accept

policy pol_1:

accept/pol_1/rip# state disabled

accept/pol_1/rip#

Table 5-1. BCC Definition Parameters for RIP Accept Policies

Parameter Values Function

state enabled (default)

disabled

Enables and disables the policy you have

created

action ignore (default)

Specifies whether the protocol ignores a route

that matches the policy or forwards the route

to the routing table manager

preference 1 (default) to 16 Assigns a metric value (the higher the

number, the greater the preference) to a route

that the protocol forwards to the routing table

manager. If confronted with multiple routes to

the same destination, the routing table

manager may use this value to decide which

route to insert. Routes for all networks

(0.0.0.0/0.0.0.0) should have the lowest

preference, and routes for the most specific

networks (longest address and mask) should

have the highest preference.

precedence 0 (default) to any

integer

Assigns a metric value to this policy (a policy

with a higher value takes precedence over a

policy with a lower value). This value

determines the order of precedence for

policies that match the same route.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 361 362

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring IP, ARP, RIP, and OSPF Services Instrukcja Użytkownika Strona 156

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya Configuring IP, ARP, RIP, and OSPF Services