Avaya Configuring IP, ARP, RIP, and OSPF Services Instrukcja Użytkownika Pobierz pdf (Strona 112)

100

101

Configuring IP, ARP, RIP, and OSPF Services

3-50

117356-E Rev 00

Using Site Manager

To define a static route, complete the following tasks:

cost 1 (default)

to RIP diameter

Specifies the number of router hops a

datagram can traverse before reaching the

destination IP address. The IP router uses

the cost value when determining the best

route for a datagram to follow. If you

enabled ECMP on the router (for

information, see “Configuring Equal-Cost

Multipath Support for RIP and OSPF” on

page 3-15), you can configure up to 12

equal-cost static routes.

preference 1 (default)

to 16

Specifies a weighted value (from 1 to 16,

with 16 being the most preferred) that the IP

router uses to select a route when its

routing tables contain multiple routes to the

same destination. To configure a black hole

static route, enter the maximum preference

value

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

. The IP menu opens.

3. Choose

Static Routes

. The IP Static Routes window opens.

4. Click on

Add

. The IP Configuration window opens.

(continued)

Table 3-5. BCC Static Route Parameters

(continued)

Parameter Values/Defaults Meaning/Instructions

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 361 362

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring IP, ARP, RIP, and OSPF Services Instrukcja Użytkownika Strona 112

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya Configuring IP, ARP, RIP, and OSPF Services