Avaya Configuring ATM and MPLS Services Instrukcja Użytkownika Pobierz pdf (Strona 163)

100

101

Customizing Signaling

117374-C Rev 00

5-15

Defining Signaling Timers

You can change the default values for signaling timers. Table 5-1 provides the

BCC name, Site Manager name, default value, range, and description for each

timer.

Caution:

Bay Networks strongly recommends that you use default timer

values. These values work properly under most ATM network conditions.

However, if you do change any of the timer values, you must also change the

values at the other end of the UNI (that is, at the local ATM switch).

Table 5-1. Signaling Timer Descriptions

BCC

Name

Site

Manager

Name

Default

Value Range Description

setup-tx-timer T303 4 1 to 24 Specifies the Setup Sent timer value (in seconds).

This timer begins when the circuit initiates a call/

connection request by sending a SETUP message

over the signaling VC.

The Setup Sent timer stops when the circuit

receives a CONNECT message (indicating

connection), a CALL PROCEEDING message

(indicating that the network received the SETUP

message), or a RELEASE COMPLETE message

(indicating the rejection of the SETUP message)

from the network.

If the circuit does not receive one of these

messages within the allotted time, it transmits the

SETUP message again. If the circuit still does not

receive a response, it clears the connection.

(continued)

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 528 529

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring ATM and MPLS Services Instrukcja Użytkownika Strona 163

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya Configuring ATM and MPLS Services