
Chapter 2 General CLI commands 95
Reference for the Business Policy Switch 2000 Command Line Interface
Table 43 describes the parameters and variables for the no flowcontrol
command.
default flowcontrol command
The default flowcontrol command is used only on Gigabit Ethernet ports
and sets the flow control to auto, which automatically detects the flow control.
The syntax for the
default flowcontrol command is:
default flowcontrol [port <portnum>]
The default flowcontrol command is in the config-if mode.
Table 43 describes the parameters and variables for the
default flowcontrol
command.
Table 43 no flowcontrol command parameters and variables
Parameters and
variables
Description
port <portnum> Specifies the port number to disable flow control.
Note: If you omit this parameter, the system uses the port
number you specified in the interface command.
Table 44 default flowcontrol command parameters and variables
Parameters and
variables
Description
port <portnum> Specifies the port number to default to auto flow control.
Note: If you omit this parameter, the system uses the port
number you specified in the
interface command.
Komentarze do niniejszej Instrukcji