Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 112)

112 Chapter 3 Security

212160-A

Using EAPOL-based security

You configure the security based on the Extensible Authentication Protocol over

LAN (EAPOL) using the following CLI commands:

• “show eapol command,” next

• “eapol command” on page 113

• “eapol command for modifying parameters” on page 113

show eapol command

The show eapol command displays the status of the EAPOL-based security. The

syntax for the

show eapol command is:

show eapol

The show eapol command is in the privExec command mode.

The

show eapol command has no parameters or variables.

The

show eapol command displays the current status of the EAPOL

parameters.

Table 58 mac-security command for a single port parameters and variables

Parameters and variables Description

port <portnum> Enter a the port number.

disable|enable|learning Directs the specific port:

• disable—disables BaySecure on the specified port

and removes the port from the list of ports for which

MAC address learning is being performed

• enable—enables BaySecure on the specified port

and removes the port from the list of ports for which

MAC address learning is being performed

• learning—disables BaySecure on the specified port

and adds these port to the list of ports for which MAC

address learning is being performed

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 112