Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 70)

70 Chapter 2 General CLI commands

212160-A

• “no ip bootp server command” on page 71

• “default ip bootp server command” on page 71

boot command

The boot command performs a soft-boot of the switch or stack. The syntax for

the

boot command is:

boot [default] [unit <unitno>]

The boot command is in the privExec command mode.

Table 20 describes the parameters and variables for the

boot command.

ip bootp server command

The ip bootp server command configures BootP on the current instance of

the switch or server. The syntax for the

ip bootp server command is:

ip bootp server {last|needed|disable|always}

Table 20 boot command parameters and variables

Parameters

and

variables

Description

default Restores switch or stack to factory-default settings after rebooting.

unit <unitno> Specifies which unit of the stack will be rebooted. This command is

available only in stack mode. Enter the unit number of the switch you

want to reboot.

Note: When you reset to factory defaults, the switch or stack retains the

stack operational mode, last reset count, and reason for last reset; these

three parameters are not defaulted to factory defaults.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 70