Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 91)

Chapter 2 General CLI commands 91

Reference for the Business Policy Switch 2000 Command Line Interface

Table 40 describes the parameters and variables for the duplex command.

default duplex command

The default duplex command sets the duplex operation for a port to the

factory default duplex value. The syntax for the

default duplex command is:

default duplex [port <portnum|all>]

The default duplex command is in the config-if command mode.

Table 40 describes the parameters and variables for the

default duplex

command.

Table 40 duplex command parameters and variables

Parameters and

variables

Description

port <portnum|all> Specifies the port number to configure the duplex mode. Enter the

port number you want to configure, or all to configure all ports

simultaneously.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

full|half|auto Sets duplex to:

• full—full-duplex mode

• half—half-duplex mode

• auto—autonegotiation

Note: When you set the duplex mode for autonegotiation, ensure that

the other side of the link is also set for autonegotiation.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 91