Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 60)

60 Chapter 2 General CLI commands

212160-A

• “no ip default-gateway command” on page 62

• “show ip command” on page 63

ip address command

The ip address command sets the IP address and subnet mask for the switch or

a stack. The syntax for the

ip address command is:

ip address [stack|switch] <XXX.XXX.XXX.XXX> [netmask

<XXX.XXX.XXX.XXX>]

The ip address command is in the config command mode.

If you do not enter either the stack or switch parameter, the system automatically

modifies the stack IP address when in stack mode and modifies the switch IP

address when in standalone mode.

Table 13 describes the parameters and variables for the

ip address command.

Table 13 ip address command parameters and variables

Parameters and

variables

Description

stack|switch Sets the stack the IP address and netmask or the switch IP

address and netmask.

XXX.XXX.XXX.XXX Enter IP address in dotted decimal notation; netmask is optional.

netmask Set the IP subnet mask for the stack or switch.

Note: When you change the IP address or subnet mask, you may lose

connection to Telnet and the Web.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 60