Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 92)

92 Chapter 2 General CLI commands

212160-A

Enabling Autopology

You can enable the Optivity* Autopology* protocol using the CLI. Refer to the

www.nortelnetworks.com/documentation URL for information on Autopology.

(The product family for Optivity and Autotopology is Data and Internet.). This

section covers the following commands:

• “autotopology command,” next

• “no autotopology command” on page 93

• “default autotopology command” on page 93

autotopology command

The autotopology command enables the Autotopology protocol. The syntax for

the

autotopology command is:

autotopology

The autotopology command is in the config command mode.

The

autotopology command has no parameters or values.

Table 41 default duplex command parameters and variables

Parameters and

variables

Description

port <portnum|all> Specifies the port number to reset the duplex mode to factory

default values. Enter the port number you want to configure, or all

to configure all ports simultaneously. The default value is

autonegotiation.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 92