Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 61)

Chapter 2 General CLI commands 61

Reference for the Business Policy Switch 2000 Command Line Interface

no ip address command

The no ip address command clears the IP address and subnet mask. This

command sets the IP address and subnet mask for a switch or a stack to all zeros

(0). The syntax for the

no ip address command is:

no ip address {stack|switch}

The no ip address command is in the config command mode.

Table 14 describes the parameters and variables for the

no ip address

command.

ip default-gateway command

The ip default-gateway command sets the IP default gateway address for a

switch or a stack to use. The syntax for the

ip default-gateway command is:

ip default-gateway <XXX.XXX.XXX.XXX>

The ip default-gateway command is in the config command mode.

Table 14 no ip address command parameters and variables

Parameters and

variables

Description

stack|switch Zeroes out the stack IP address and subnet mask or the switch IP

address and subnet mask.

Note: When you change the IP address or subnet mask, you may lose

connection to Telnet and the Web.You also disable any new Telnet

connection, and you must connect to the serial console port to configure

a new IP address.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 61