Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 129)

Chapter 4 Spanning Tree, MLT, and Port-Mirroring 129

Reference for the Business Policy Switch 2000 Command Line Interface

spanning-tree command by port

The spanning-tree command by port sets Spanning Tree Protocol (STP) and

multiple spanning tree group (STG) participation for the ports within the specified

spanning tree group. The syntax for the

spanning-tree command by port is:

spanning-tree [port <portnum>] [stp <1-8>] [learning

{disable|normal|fast}] [cost <1-65535>] [priority <0-255>]

The spanning-tree command by port is in the config-if command mode.

Table 71 describes the parameters and variables for the

spanning-tree

command by port.

Table 70 spanning-tree remove-vlan command parameters and variables

Parameters and

variables

Description

stp <1-8> Specifies the spanning tree group you want to remove the VLAN

from; enter the STG ID.

Note: If you omit this parameter, the system uses the default

spanning tree group, 1.

remove-vlan

<1-4094>

Enter the VLAN you want to remove from the spanning tree

group.

Note: You cannot remove VLAN 1 from spanning tree group 1.

Note: For guidelines for configuring STGs, VLANs, and MLTs, refer to

Chapter 1 of the Using the Business Policy Switch 2000 Software Version

1.2.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 129