Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Pobierz pdf (Strona 56)

56 Chapter 2 General CLI commands

212160-A

Pinging

To ensure that the BPS 2000 has connectivity to the network, ping a device you

know is connected to this network.

ping command

The ping command tests the network connection to another network device. The

command sends an Internet Control Message Protocol (ICMP) packet from the

switch to the target device. The local IP address must be set before issuing the

ping command.

The syntax for the

ping command is:

ping <XXX.XXX.XXX.XXX>

The ping command is in the exec command mode.

Table 11 describes the parameters and variables for the

ping command.

Table 10 terminal command parameters and variables

Parameters and

variables

Description

speed

{2400|4800|9600|

19200|38400}

Sets the transmit and receive baud rates for the terminal. You can

set the speed at one of the five options shown; default is 9600.

length Sets the length of the terminal display in characters; default is 24.

width Sets the width of the terminal displaying characters; default 79.

Note: Refer to “Assigning and clearing IP addresses” on page 59 for

information on setting IP addresses.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 199 200

Brak uwag

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Instrukcja Użytkownika Strona 56