
172 Chapter 6 Policy-enabled networks and QoS
212160-A
Configuring DSCP and 802.1p and queue associations
You can configure the DSCP, IEEE 802.1p priority, and queue set association
using the CLI. This section covers:
• “qos egressmap command,” next
• “qos ingressmap command” on page 173
• “qos queue-set-assignment command” on page 174
qos egressmap command
The qos egressmap command configures DSCP-to-802.1p priority and drop
precedence associations that are used for assigning these values at packet egress,
based on the DSCP in the received packet. The syntax for the
qos egressmap
command is:
qos egressmap ds <dscp> 1p <ieee1p> dp <dropprec>
The qos egressmap command is in the config command mode.
Table 98 describes the parameters and variables for the
qos egressmap
command.
Note: You cannot delete interface groups that are referenced by an
installed policy or associated with device interfaces.
Komentarze do niniejszej Instrukcji