Avaya Using Technician Interface Software Instrukcja Użytkownika Pobierz pdf (Strona 298)

Using Technician Interface Software

C-4

Remote Hosts and Filters

You use a management workstation to monitor event messages generated by

speciﬁc software entities on each router in your network. To receive at a

management workstation event messages from a router, you must

• Enable Syslog on the router.

• Deﬁne in the Syslog host table any remote hosts you want to receive

messages.

• Conﬁgure entity-speciﬁc message ﬁlters for each host.

You can conﬁgure entity ﬁlters by means of the Conﬁguration Manager tool under

Site Manager, or by means of set and commit commands you enter at the

Technician Interface of the router.

Each entity ﬁlter selects only event messages that

• Originate from a router software entity that you specify by entity number

AND

• Have an event message number OR severity level that matches one of the

values you conﬁgured AND

• Originate from a router slot you specify

Figure C-2 illustrates how an entity ﬁlter limits the number of event messages

forwarded by Syslog from a router to a speciﬁc remote host. Each ﬁlter attribute

or parameter (entity number, event numbers or severity levels, and slot numbers)

that you specify increases the selectivity of a ﬁlter.

Note: This appendix covers Syslog conﬁguration via Technician Interface

commands only. (For information on how to conﬁgure Syslog through Site

Manager, refer to the guide Managing Routers and BNX Platforms.)

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 351 352

Brak uwag

Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 298