Avaya Using Technician Interface Software Instrukcja Użytkownika Pobierz pdf (Strona 242)

Using Technician Interface Software

9-10

You can display the commands associated with an alias loaded in memory in two

ways:

• You can use the

alias command to display the commands without invoking

them.

• You can use the

verbose command to display the commands associated with

an alias

whenever an alias executes.

Examples:

Table 9-1. Aliases for Debugging Network Problems

If you enter: The system:

at_intf

[1 | 2] Enables or disables a circuit. Valid values are

1 = Enable circuit

2 = Disable circuit

at_if

<circuit_no>

Retrieves conﬁguration information and statistics for

the selected circuit.

at_addr Lists the AppleTalk addresses for the AppleTalk

interfaces on the router.

at_cfg Displays the conﬁgured network start, network end,

and default zone for all AppleTalk interfaces.

at_cur Displays the current network start, network end, and

default zone for all AppleTalk interfaces.

at_it Displays the status of all AppleTalk interfaces.

at_rt Displays the entries in the routing table, including the

node and network IDs of the next hops in the network,

the number of hops, and the status of the network.

at_zones Lists the zones in the router’s zone table.

at_arp Lists the AARP entries in the router’s address mapping

table.

/jointfilesconvert/93594/bgpenabled Displays the state of all conﬁgured BGP connections.

Valid values are

1 = Enabled

2 = Disabled

/jointfilesconvert/93594/bgppeers Displays the BGP IDs (for the connections that are

established) of all BGP peers.

(continued)

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 351 352

Brak uwag

Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 242