
Using Technician Interface Software
2-2 114088 Rev. A
Overview
You access the Technician Interface software through a console or modem
attached to a router serial port. The number of Technician Interface sessions you
can establish for a router depends on the number of serial ports available on that
router.
• The SRM-L board has one serial port (labeled “Console”), allowing you to
establish 1 session.
• The SYS I/O board has 3 serial ports (labeled “Console,”
“Modem 1” and “Modem 2”), allowing you to establish up to 3 sessions.
• The AFN motherboard has two serial ports (labeled “Console” and
“Modem”), allowing you to establish 1 or 2 sessions.
• The AN motherboard has 1 serial port (labeled “Console”), allowing you to
establish 1 session.
• The ASN motherboard has one serial port per router, with up to 4 routers
stacked, allowing you to establish up to 4 sessions with the interconnected
stack.
Refer to Configuring Routers if you prefer to user Site Manager to configure the
serial port parameters for the router console.
Configuring Console Port Parameters
The following sections describe how to use the following Technician Interface
commands:
• list
• set
• commit
•save
Using the list Command
You can list and review all serial port attributes by entering the following
command line at the Technician Interface prompt:
list wfSerialPortEntry
Komentarze do niniejszej Instrukcji