
Using Technician Interface Software
8-2
114088 Rev. A
• Enable/disable SecurID authentication
• Manage Secure Mode
• Configure search depth for hardware compression
• Display a greeting or message before the login prompt
• Customize the Technician Interface Welcome message
• Record console messages to a file
• Enable Internal Clocking Mode
• Respond to QENET Underflow Errors
• Monitor IP routes (for IP, OSPF, BGP)
A table of all the Technician Interface commands and their associated access
levels appears at the end of this chapter (Table 8-4).
AN/ANH/ASN Administration
The following sections apply to the Access Node (AN), Access Node Hub (ANH),
and Access Stack Node (ASN) routers. The following guides collectively provide
complete instructions for setting up Netboot and Directed Netboot on an AN,
ANH, or ASN router:
• Installing and Operating BayStack AN and ANH Systems
• Installing and Maintaining ASN Routers and BNX Platforms
• Connecting BayStack AN and ANH Systems to a Network
• Connecting ASN Routers and BNX Platforms to a Network
You need to use the
ifconfig
and
bconfig
commands to configure the AN, ANH,
and ASN:
• Use the
ifconfig
command to configure the router’s initial IP interface to the
network.
• Use the
bconfig
command to specify the location and name of the router’s
software image and configuration file.
Komentarze do niniejszej Instrukcji