Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 169

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 366
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 168
System Administration
114088 Rev. A
8-5
Configuring Initial Interfaces and Netboot Operation
You can use the
ifconfig
command to do the following:
Configure the router’s initial IP interface to the network. You also use the
same procedure to configure other synchronous interfaces for the network
booting procedure.
Configure Ethernet interfaces for the network booting procedure.
Enable or disable network booting on an interface.
The following sections describe each use of the
ifconfig
command.
Configuring the Initial IP Synchronous Interface
To Netboot the router, you must first configure the router’s initial IP synchronous
interface to the network, using the following interface configuration command:
ifconfig
[
-s
<slot_no.>
]
<synchronous_options>
<interface>
[
<IP_address>
<subnet_mask>
[
<next_hop_address>
]]
<synchronous_options>
indicates some combination of the following settings:
[
-d
|
-fr
[
-annexd
|
-lmi
|
-annexa
]
|
-int_clk
]
You can use the same command format to configure other synchronous interfaces
on the router for network booting.
Table
8-2 describes the
ifconfig
command arguments for configuring a router’s
synchronous interface.
Note:
You must insert a space to separate each command option from the next.
Przeglądanie stron 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 365 366

Komentarze do niniejszej Instrukcji

Brak uwag