
Troubleshooting Routers
A-10
Slot 3 is booting revision 9.00 of bn.exe.
@ 176: mm/dd/yy 11:48:41.007 INFO # 3 GAME ( 11) Starting image
rel/9.00 Fri Jul 28 17:12:26 EST 1995
The transceiver on Slot 2, Connector 1, does not have SQE (signal quality error)
enabled. It reports the absence of an SQE signal, even though it does not need it.
@ 193: mm/dd/yy 11:48:45.018 WARN # 2 CSMACD ( 7) Connector
XCVR1 no SQE.
Data Path elects the circuit control gate for Circuit 1. Each circuit must have a
circuit control gate.
@ 195: mm/dd/yy 11:48:45.025 DEBUG # 2 DP ( 23) Creating
Circuit 1 soloist with line GH 0x4082
@ 196: mm/dd/yy 11:48:45.025 DEBUG # 2 GAME ( 23) SOLO
(0x00401): election opening 30000000/30000000 (30000000) vote=00000000
@ 197: mm/dd/yy 11:48:45.049 DEBUG # 2 GAME ( 97) SOLO
(0x00401): election WON 0x20000000 (repl=b0000009/30000000)
@ 198: mm/dd/yy 11:48:45.053 DEBUG # 2 GAME ( 23) SOLO
(0x00401): election CLOSING 30000000/30000000 (30000000) vote=00000000
ARP successfully initializes on Circuit 1.
@ 199: mm/dd/yy 11:48:45.057 INFO # 2 ARP ( 1) Service is up
on circuit 1
Data Path registers the ISAP (internal services access point) for ARP. The
protocol type for ARP is 0806; this type determines that the ARP traffic will go to
the correct gate and code by the DP (Data Path). The number preceding the
protocol type indicates the packet format (1 = Ethernet type 2, 2 = 802.2,
3 = SNAP [Subnetwork Access Protocol] , 4 = Novell, and so on). Data Path
registers Ethernet Type II or SNAP ARP frames on Circuit 1. In this example,
Data Path does not register the 802.2 ARP frame type. If Circuit 1 received an
802.2 ARP frame, ARP would not receive it; instead it would go to the learning
bridge.
@ 201: mm/dd/yy 11:48:45.135 DEBUG # 2 DP ( 34) ISAP 0x30806
registered on cct 1.
@ 202: mm/dd/yy 11:48:45.140 DEBUG # 2 DP ( 34) ISAP 0x10806
registered on cct 1.
@ 205: mm/dd/yy 11:48:45.213 DEBUG # 2 ARP ( 3) Arp Client
128.128.2.2 registered
Komentarze do niniejszej Instrukcji