Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Instrukcja Użytkownika Pobierz pdf (Strona 21)

Starting SNMP, BootP, DHCP, and RARP Services

303542-A Rev 00

1-3

When you have successfully configured the circuit, the Select Protocols window

opens. Proceed as follows:

Using the BCC

To start IP on the router:

Configure a physical interface on an available slot/connector.

Configure an IP interface on the physical interface.

Step 1: Configuring a Physical Interface

To configure a physical interface on a slot and connector, navigate to the top-level

box prompt and enter:

interface_type

slot

slot_number

connector

connector_number

interface_type is the name of a link module on the router.

slot_number is the number of the slot on which the link module is located.

connector_number

is the number of a connector on the link module.

For example, the following command configures an Ethernet interface on slot 1,

connector 2.

box#

ethernet slot 1 connector 2

ethernet/1/2#

Site Manager Procedure

You do this System responds

1. In the Select Protocols window, select

Then click on

The IP Configuration window opens.

2. Set the following parameters:

•

IP Address

•

Subnet Mask

•

Transmit Bcast Addr

•

UnNumbered Assoc Address

Click on

Help

or refer to

Configuring IP

Services

for parameter descriptions.

3. Click on

. You return to the Configuration Manager

window.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 145 146

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Instrukcja Użytkownika Strona 21

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services