Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Instrukcja Użytkownika Strona 15

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 146
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 14
303542-A Rev 00
xv
Preface
This guide describes how to configure Simple Network Management Protocol
(SNMP), Bootstrap Protocol (BootP), Dynamic Host Configuration Protocol
(DHCP), and Reverse Address Resolution Protocol (RARP) on Bay Networks
®
routers or BayStream
platforms.
You can use the Bay Command Console (BCC
) or Site Manager to configure
SNMP on a router; you must use Site Manager to configure BootP, DHCP, and
RARP services. In this guide, you will find instructions for using both the BCC
and Site Manager.
Before You Begin
Before using this guide with a new router, you must complete the following
procedures:
Install the router (refer to the installation manual that came with your router).
Connect the router to the network and create a pilot configuration file (see
Quick-Starting Routers, Configuring BayStack Remote Access, or Connecting
ASN Routers to a Network).
Make sure that you are running the latest version of Bay Networks BayRS
and
Site Manager software. For information about upgrading BayRS and Site
Manager, see the upgrading guide for your version of BayRS.
Przeglądanie stron 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 145 146

Komentarze do niniejszej Instrukcji

Brak uwag