Avaya BCM 4.0 Networking Przewodnik Konfiguracji Pobierz pdf (Strona 619)

100

101

Chapter 66 Configuring NAT (Network Address Translation) 619

BCM 4.0 Networking Configuration Guide

Modifying a Rule to an Interface

1 Click Configuration > Data Services > NAT and Filters > Interfaces tab.

2 Click the interface you want to configure.

The details panel appears.

3 Click the NAT Inbound Rules Tab or NAT Outbound Rules Tab.

4 Select the rule to modify.

5 Click the Modify button.

The Modify NAT Inbound/Outbound Rule panel appears.

6 Modify the Rule settings.

7 Click OK.

Public port Specify a single entry for one of the following; ALL, FTP,

Telnet, SMTP, SNMP, SNMP-TRAP, DNS, TFTP, Gopher,

Finger, H.323, SIP, HTTP, HTTPS, POP3, NNTP, SUNRPC,

SUNNFS, UNISTIM, or CUSTOM.

Note: If CUSTOM is used, Public start port and Public end

port must be set

Action

OK <button> Click to add entry.

Cancel <button> Click to cancel entry.

Note: If you do not configure the public and private masks correctly, mappings to

non-existent systems can occur. You must specify both Private and Public addresses that

exist on the BCM. For example, if you configure an outbound rule, the Public IP address

and Public Mask are the translated addresses. These addresses must be assigned or packets

will be sent to a non-existent destination. For inbound rules, the translated address is the

Private Address and Mask.

If you want the rule to apply to one IP address only, you must enter a Mask of

255.255.255.255. If you enter any other Mask, the rule will apply to more than one IP

address.

Table 23 NAT Inbound Rule Settings (Sheet 3 of 3)

Attribute Value Description

1 2 ... 614 615 616 617 618 619 620 621 622 623 624 ... 757 758

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya BCM 4.0 Networking Przewodnik Konfiguracji Strona 619

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya BCM 4.0 Networking