Avaya BCM 4.0 Networking Przewodnik Konfiguracji Pobierz pdf (Strona 171)

100

101

Chapter 10 Configuring lines 171

BCM 4.0 Networking Configuration Guide

Preferences (lines)

The Preferences tab shows information that may vary from trunk to trunk. Most of this information

needs to coordinate with the line service provider equipment.

Figure 53 shows the Preferences tab.

Link at CO

Loop (analog only)

<check box> Some exchanges respond to a Link signal, also called hook flash

(FEATURE 71), by providing an alternative line for making outgoing

calls.

Enabling Link at CO causes the system to apply the restrictions on

outgoing calls to the digits dialed after the Link signal. As well, the call

on the alternative line is subject to all restrictions.

Disabling Link at CO prevents a Link signal from resetting the BCM

restrictions in cases where the host exchange does not provide an

alternative line.

Link time

Loop (analog only)

<time> Link at CO is enabled.

The duration of the on-hook signal sent when the user activates the

Link feature.

Dial tone (detect

delay)

Loop (analog only)

Detect

Delay

This field tells the system to either detect a dial tone before sending the

dialstring, or to wait a period of time and then send the dial string.

Table 42 Properties line settings (Sheet 2 of 2)

Attribute Value Description

Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS = DPNSS;

VoIP = VoIP; TL = Target. Note: PRI fields are all included under the main table.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 757 758

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya BCM 4.0 Networking Przewodnik Konfiguracji Strona 171

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya BCM 4.0 Networking