Avaya BCM 4.0 Networking Przewodnik Konfiguracji Pobierz pdf (Strona 226)

100

101

226 Chapter 19 BRI ISDN: BRI T-loops

N0060606N0060606

Prerequisites:

Configuring provisioned BRI line features

The following procedure describes the fields that need to be confirmed or set for these lines. For

detailed field descriptions, refer to “Configuring lines” on page 165.

To configure provisioned BRI line features

1 Confirm or change the settings on the Trunk/Line Data main panel:

• Trunk Type: BRI-ST (determined by profile and type of BRI module)

• Name: Identify the line or line function.

• Control Set: Identify a DN if you are using this line with scheduling.

• Line Type: Define how the line will be used. If you are using routing, ensure it is put into

line pool (A to O).

• Prime Set: If you want the line to be answered at another telephone if the line is not

answered at the target telephone, otherwise, choose None.

• Pub. Received #: Not applicable.

• Priv. Received#: Not applicable.

• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, or 4).

• Subpanel, under Restrictions tab: Use remote package: If this line is used for remote

call-ins or is part of a private network, ensure you specify a valid package.

2 Configure the trunk/line data (Properties tab):

• Auto privacy: If you activate this feature, the line is available only to the telephone that

answers the call.

• Answer mode/Answer with DISA: If this line is used for remote call-ins, determine how

you want the line to answer (automatically, or requiring more user input). If the answer

mode is set to Automatic, decide whether the caller will be immediately connected to the

system or whether a stuttered dial tone will require the caller to enter a CoS password.

• Aux. ringer: If your system is equipped with an external ringer, you can enable this setting

to allow this line to ring at the external ringer.

• Full autohold: This allows telephones to put a line on hold if the user picks up another line

or starts to dial out on another line.

• Voice Message Center: If the system is using a remote voice mail, pick the center

configured with the contact number.

BRI module: Installed and configured. Refer to “Trunk Module Parameters” on

page 124.

BRI loops are configured as T loops. Refer to “Configuring BRI T-loop

parameters” on page 225.

BRI loop lines are provisioned. Refer to “Provisioning module lines/loops” on

page 132.

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 757 758

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya BCM 4.0 Networking Przewodnik Konfiguracji Strona 226

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya BCM 4.0 Networking