Avaya BCM 4.0 Networking Przewodnik Konfiguracji Pobierz pdf (Strona 579)

100

101

Chapter 64 Configuring IP Routing 579

BCM 4.0 Networking Configuration Guide

Configuring IP routing on an interface

After you configure the IP Routing global settings, you must configure each available network

interface to use the routing protocol of your choice or static routes.

The following provides instructions on how to configure interfaces for IP routing and how to

create static routes. The available interfaces appear under the IP Routing heading. Follow the

same instructions to configure all interfaces. For information on how to create static routes, see

“Static routes” on page 573.

Refer to the following topics:

• “Configuring RIP parameters on a network interface”

• “Configuring OSPF Parameters on a network interface” on page 583

• “OSPF NBMA Neighbors” on page 586

• “Static routes” on page 573

Configuring RIP parameters on a network interface

To configure RIP parameters on a network interface

1 Click Configuration > Data Services > Router > Global Settings tab.

2 Select RIP from the Routing protocol drop-down list.

Authentication type None

Password

Specify the type of OSPF authentication used.

If the Authentication Type component is set to “Password” directly

connected OSPF interfaces between 2 routers will establish an

OSPF adjacency only if they use the same password.

Note: If password is selected as the authentication type, interfaces

can still have blank/empty passwords set on both sides.

Default: None

OSPF log levels All

Critical

Warning

Information

Disabled

Enable the recording of events in the Operational logs.

All, for logging all information in the Element Manager.

Critical for logging critical errors and warnings in the Element

Manager.

Warning, for logging warnings in the Element Manager.

Information for logging Information events in the Element Manager.

Disabled, to disable event logs.

Default: Disabled

Note: You must use the same routing protocol on all interfaces. For example, you can not

configure your LAN1 interface to use RIP and your WAN1 interface to use OSPF.

Table 137 IP Routing settings (Sheet 3 of 3)

Attribute Value Description

1 2 ... 574 575 576 577 578 579 580 581 582 583 584 ... 757 758

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya BCM 4.0 Networking Przewodnik Konfiguracji Strona 579

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya BCM 4.0 Networking