Avaya Upgrading Routers from Version 5 to Version 10.0 Instrukcja Użytkownika Pobierz pdf (Strona 47)

Continuing the Upgrade: Converting and Customizing Files

4-15

Redeﬁning Point-to-Point Circuits

If the router you are upgrading needs to support PPP over a synchronous line, read

this section.

Before running convert.exe, you deleted from your Version 5 conﬁg ﬁle any

synchronous lines running PPP. If ﬁle conversion was successful, you can restore

the synchronous lines running PPP in your new (Version 10.0) conﬁg ﬁle.

For information on how to use the Conﬁguration Manager to enable PPP on a

synchronous line, refer to Conﬁguring PPP Services.

If you need to conﬁgure PPP on a synchronous line between a Version 5 router

and a Version 10.0 router, refer to Appendix B.

Redeﬁning Frame Relay Circuits

If the router needs to support Frame Relay circuits, follow the instructions in this

section.

Deleting and Conﬁguring Frame Relay Interfaces

The upgrade procedure does not convert all Frame Relay circuit records. Some

Site Manager screens will not display unconverted records. You must delete all

interfaces on which Frame Relay was conﬁgured and reconﬁgure them, as

follows:

1. Open the conﬁghd ﬁle, which is your most up-to-date conﬁguration ﬁle,

using the Conﬁguration Manager.

2. Select Circuits➔Delete Circuits.

The Circuit List window displays the circuits.

3. Select each circuit on which Frame Relay was conﬁgured in the original

Version 5 conﬁg ﬁle you converted.

4. Select Delete.

5. Select Done.

Note: This ﬁle is already open if you followed the steps in the previous section

and did not exit. Note that the ﬁlename appears near the top of the window.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Brak uwag

Avaya Upgrading Routers from Version 5 to Version 10.0 Instrukcja Użytkownika Strona 47