
Configuring Dial Services
7-56 114062 Rev. A
To remove a dial service from an ISDN line, refer to “Modifying the Logical
Lines Configuration” on page 7-62.
To remove a dial service from a COM line or to add additional lines to a pool:
1. Select Dialup > Demand, Backup, or Bandwidth-on-Demand Pool ID
from the Configuration Manager window.
Site Manager displays the Pools window (refer to Figure
7-24).
2. Highlight the pool ID of the lines you want to modify. Click on Edit.
The Lines Definition window (refer to Figure
7-4) appears.
• To remove a dial service from a line, click once on the line. If this is the
only line in the pool, the Site Manager deletes the pool as well.
• To add additional lines, repeat the steps in “Creating Line Pools with
Raise DTR and V.25bis Interfaces” (page 7-3) or “Creating Line Pools
with ISDN Interfaces” (page 7-38).
3. Select File > Exit.
Site Manager returns you to the Pools window (refer to Figure
7-24).
4. Click on Done in the Pools window when you finish modifying lines.
Changing the WAN Interface and Line Media Type
To edit the WAN interface type and the line media parameters, follow these steps.
1. Click on the COM port you want to edit.
Site Manager displays the Edit Connector window (refer to Figure
7-10).
2. Click on Edit Line.
Site Manager displays the Synchronous Line Details window where you will
find the WAN Serial Interface parameter as well as the Line Media Type and
Cable Type parameters.
Caution: If you make changes to a line that is carrying an active circuit, the
router terminates the circuit.
Komentarze do niniejszej Instrukcji