Avaya Business Secure Router 252 Configuration - Basics Instrukcja Użytkownika Pobierz pdf (Strona 116)

116 Chapter 7 WAN screens

NN47923-500

RIP Direction With RIP (Routing Information Protocol), a router can exchange

routing information with other routers. The RIP Direction field

controls the sending and receiving of RIP packets.

Choose Both, None, In Only or Out Only.

When set to Both or Out Only, the Business Secure Router

broadcasts its routing table periodically.

When set to Both or In Only, the Business Secure Router

incorporates RIP information that it receives.

When set to None, the Business Secure Router does not send any

RIP packets and ignores any RIP packets received.

By default, RIP Direction is set to Both.

RIP Version The RIP Version field controls the format and the broadcasting

method of the RIP packets that the Business Secure Router sends

(it recognizes both formats when receiving).

Choose RIP-1, RIP-2B or RIP-2M.

RIP-1 is universally supported; but RIP-2 carries more information.

RIP-1 is probably adequate for most networks, unless you have an

unusual network topology. Both RIP-2B and RIP-2M sends the

routing data in RIP-2 format; the difference being that RIP-2B uses

subnet broadcasting while RIP-2M uses multicasting. Multicasting

can reduce the load on nonrouter machines since they generally do

not listen to the RIP multicast address and so do not receive the

RIP packets. However, if one router uses multicasting, then all

routers on your network must use multicasting, also. By default, the

RIP Version field is set to RIP-1.

Multicast Choose None (default), IGMP-V1 or IGMP-V2. IGMP (Internet

Group Multicast Protocol) is a network layer protocol used to

establish membership in a Multicast group—it is not used to carry

user data. IGMP version 2 (RFC 2236) is an improvement over

version 1 (RFC 1112) but IGMP version 1 is still in wide use. If you

want to read more detailed information about interoperability

between IGMP version 2 and version 1, see sections 4 and 5 of

Internet Group Management Protocol

(RFC 2236).

Call Schedule

(PPPoE and

PPPoA

encapsulation)

Apply call schedule sets for this remote node. Use the Call

Schedule screens to configure call schedule sets (see Chapter 21,

“Call scheduling screens,” on page 387).

Windows

Networking

(NetBIOS over

TCP/IP):

Windows Networking (NetBIOS over TCP/IP): NetBIOS (Network

Basic Input/Output System) are TCP or UDP packets that enable a

computer to connect to and communicate with a LAN. For some

dial-up services, such as PPPoE, NetBIOS packets cause

unwanted calls.

Table 19 WAN: IP

Label Description

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 459 460

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Business Secure Router 252 Configuration - Basics Instrukcja Użytkownika Strona 116

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Avaya Business Secure Router 252 Configuration - Basics