Avaya SIP Software 4.0 for 1200 Series Instrukcja Użytkownika Pobierz pdf (Strona 72)

the IP Deskphone is not logged in.

- * - indicates that the IP Deskphone should use its mac address (lower case) as the

User ID

- userID@domain name - the user ID must be followed by the domain name; for

example, jsmith@mycompany.com; [email protected].

Note:

o provision AUTOLOGIN_ID_KEY01, the IP Deskphone must be rebooted after the

IP Deskphone configuration file is updated. To force a hard reboot after the

IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the

device configuration file.

• AUTOLOGIN_PASSWD_KEY01 — This parameter is located within the IP Deskphone-

specific configuration file. There is no default password. If this is blank and

AUTOLOGIN_ENABLE is configured to USE_AUTOLOGIN_ID (or 2) in the device

configuration file, then the IP Deskphone does not log on.

Note:

o provision AUTOLOGIN_PASSWD_KEY01, the IP Deskphone must be rebooted

after the IP Deskphone configuration file is updated. To force a hard reboot after the

IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the

device configuration file.

Create the Dialing Plan file on the provisioning server

A dialing plan essentially describes the number and pattern of digits that a user dials to reach

a particular telephone number. Access codes, area codes, specialized codes, and

combinations of the number of digits dialed are all part of a dialing plan.

The purpose of the dialing plan is so that the end user does not have to press the send or

pound key (#) to have the IP Deskphone with SIP Software send the initial message to start

the call.

Dialing a telephone number on an IP Deskphone that supports SIP can be different than dialing

a number from a traditional telephone. SIP signaling is communicated through a SIP URI to

get to the far end. For example, you can key in the SIP address, jsmith@yourcompany.com to

reach John Smith. When the IP Deskphone with SIP Software receives this address, the dialing

plan is bypassed and the IP Deskphone uses the SIP URI to send a SIP INVITE to

jsmith@yourcompany.com (INVITE sip: jsmith@yourcompany.com).

Entering a SIP URI address, however, is inconvenient for an IP Deskphone with SIP Software.

Also, the user must explicitly press the send key (or use some method to indicate the end of

the URI) to indicate the completion of the SIP address. This is not something that the user is

accustomed to in a traditional PBX environment.

The alternative is to use a URI where numbers are used to reach the far end. Using different

access codes, the IP Deskphone with SIP Software translates the digits entered into something

Configure the provisioning server

72 SIP Software for Avaya 1200 Series IP Deskphones-Administration November 2012

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 323 324

Brak uwag

Avaya SIP Software 4.0 for 1200 Series Instrukcja Użytkownika Strona 72