Avaya Connecting ASN Routers and BNX Platforms to a Network Instrukcja Użytkownika Pobierz pdf (Strona 84)

Connecting ASN Routers and BNX Platforms to a Network

A-4

Contact your local Bay Networks Technical Response Center if you perform the

instructions in these sections and cannot ﬁnd and correct the problem.

Upstream Router Not Receiving BOOTP Requests

If the upstream router is not receiving BOOTP request messages, do the

following:

1. Issue the Technician Interface getcfg or ifconﬁg command to display the

router parameters and the

bconﬁg command to correct them if necessary.

Refer to “Displaying the ASN’s Parameter Settings” and “Changing the

ASN’s Parameter Settings” later in this appendix if you need instructions.

2. Make sure that you enter the proper command at the router console to

conﬁgure the ASN’s initial IP interface.

Refer to Chapter 4 if you need instructions.

3. Make sure that the ASN’s synchronous port conﬁgured for EZ-Install is

cabled to the upstream router, or that the port conﬁgured for Netboot

(synchronous or Ethernet) is cabled properly.

Router Not Sending BOOTP Responses

If a router is receiving BOOTP request messages but failing to return BOOTP

responses, do the following:

1. Use Site Manager to make sure the BOOTP Relay Agent Forwarding

Table associated with the router shows an IP address that is conﬁgured

on the IP router.

Make sure that the input IP address is correct. If the Hops count is lower than

the router’s position in the path, increase it.

Refer to “Creating BOOTP Relay Agent Forwarding Tables” in Chapter 3 if

you need instructions.

2. Use the Conﬁguration Manager to make sure that BOOTP and IP are

enabled on the incoming and outgoing interfaces.

3. Make sure that the link modules and drivers are enabled.

Refer to Conﬁguring Routers or Conﬁguring Customer Access and Trunks

(BNX Software), depending on the type of installed software, if you need

instructions.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 105 106

Brak uwag

Avaya Connecting ASN Routers and BNX Platforms to a Network Instrukcja Użytkownika Strona 84