Avaya Synchronous Net Modules in an ASN Platform Instrukcja Użytkownika Pobierz pdf (Strona 22)

Installing Synchronous Net Modules in an ASN Platform

Installing a Net Module2

BNX Software Version <x.x> Test Part Number

Removing the Component Tray

You need a Phillips screwdriver to complete this procedure.

To remove the component tray:

Power off the ASN.

Detach all cables, including the power cable, from the ASN back panel.

Using a Phillips screwdriver, loosen the two captive screws that fasten the

tray to the chassis (Figure 1-1).

Pull the two captive screws and gently slide the tray out of the chassis

a few inches (Figure 1-1).

Hold the sides and bottom of the tray to support it as you slide it out.

Try to keep the tray level as you slide it out.

Place the tray on a sturdy work surface.

Caution:

Do not touch any components or boards in the ASN until you have

attached an antistatic wrist strap. See the next section, “Attaching the

Antistatic Wrist Strap.”

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Brak uwag

Avaya Synchronous Net Modules in an ASN Platform Instrukcja Użytkownika Strona 22