Avaya VoIP Monitoring Manager Reference Release 3.1 Instrukcja Użytkownika Pobierz pdf (Strona 14)

Avaya VoIP Monitoring Manager Reference

Configure IP-Network-Region form

You must configure two Switch Administration Forms (SAT) on Avaya Communication Manager

to send RTCP reports to the RTCP Monitor. These forms are called the ip-network-region form

and the system-parameters ip-options form.

Configuration for the ip-network-region form

 Set the RTCP Reporting Enabled? field to y (yes).

 Set Use Default Server Parameters? field to y (yes). This indicates that this network

region uses the default values specified previously on the system-parameters-ip-options

form as well.

Why you might not want to use the default parameters?

Multiple VoIP Monitoring Manager Servers might be installed on a large system in order to reduce

the network traffic between a set of endpoints and the RTCP Monitor (for example, low bandwidth

link between endpoints in one network region and a remote RTCP Monitor). The network traffic

due to RTCP reports being sent from the endpoints to the RTCP Monitor is usually low, less than

40 bytes per second per currently active VoIP call (RTP session). Therefore, it is usually

unnecessary to have multiple RTCP Monitors.

If multiple VoIP Monitoring Manager Servers are installed on the system, then the endpoints in

each network region can be configured to send their RTCP reports to different RTCP Monitors.

To configure the endpoints in each network region to send their RTCP reports to different RTCP

Monitors, perform the following steps:

 Set Use Default Server Parameters? field to n (yes).

 Specify the IP address of the Windows 2000 PC running the VoIP Monitoring Manager

Server for that network region.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 113 114

Brak uwag

Avaya VoIP Monitoring Manager Reference Release 3.1 Instrukcja Użytkownika Strona 14