Avaya Using Technician Interface Software Instrukcja Użytkownika Pobierz pdf (Strona 309)

Using Syslog Messaging to Monitor Router Events

308657-14.00 Rev 00

C-21

Task 9: Logging Out of the Technician Interface

Enter at the Technician Interface command line interface the following command:

$: logout

For more information about how to close a Technician Interface session with a

Nortel Networks router, see Chapter 1.

Managing Syslog on a Router

Once you finish configuring Syslog on a router, you may occasionally need to:

• Disable or reenable the entire Syslog entity on the router. (See the next

section, “Disabling or Reenabling Syslog on the Router

.”)

• Disable or reenable a Syslog host or filter on the router. (See “Disabling or

Reenabling Syslog Hosts or Filters” on page C-22.)

• Delete remote hosts or entity filters from the current Syslog configuration.

(Refer in this section to “Deleting Remote Hosts or Entity Filters from the

Syslog Configuration.”)

• Delete Syslog from the router. (See “Deleting Syslog from the Router

” on

page C-24

Disabling or Reenabling Syslog on the Router

You can, if necessary, disable the Syslog service anytime after enabling it on a

router. Enter the following command line to disable Syslog:

$: set wfSyslog.wfSyslogDisable.0 2;commit

Disabling Syslog on the router:

• Transitions all Syslog hosts and their filters to an INACTIVE operational state

in the router configuration

• Halts all message forwarding from Syslog to any Syslog hosts configured on

the router

You can also reenable Syslog after disabling it on a router. Enter the following

command line to reenable Syslog:

$: set wfSyslog.wfSyslogDisable.0 1;commit

1 2 ... 304 305 306 307 308 309 310 311 312 313 314 ... 343 344

Brak uwag

Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 309