Avaya Using Technician Interface Software Instrukcja Użytkownika Pobierz pdf (Strona 303)

Using Syslog Messaging to Monitor Router Events

308657-14.00 Rev 00

C-15

Task 2: Defining a Slot Mask for Syslog on the Router

Before creating the Syslog entity on the router, define a slot mask for Syslog. The

slot mask identifies the slots on which the system will load and run the Syslog

entity. At the Technician Interface prompt, enter:

$: set wfProtocols.wfSYSLLoad.0 0x7FFE0000;commit

This command enables Syslog to run on all slots, regardless of the router model.

Next, create the Syslog entity on the router.

Task 3: Creating Syslog on the Router

Create the Syslog entity in the router configuration, as follows:

set wfSyslog.wfSyslogDelete.0

1;commit

This also enables Syslog on the router. (The system sets the attribute

wfSyslogDisable, OID = 1.3.6.1.4.1.18.3.3.2.15.1.2, in the Syslog base record to a

value of 1.)

Next, configure the Syslog global attributes.

Task 4: Configuring Syslog Global Attributes

Once you create and enable Syslog on the router, you can accept the default values

for the wfSyslogMaxHosts and wfSyslogPollTimer attributes, or you can

configure a customized value for either attribute. If you want to accept default

values for the Syslog global attributes, go to Task 5; otherwise, perform the

following steps:

Configure the maximum number of active hosts served by Syslog on the

router:

$: set wfSyslog.wfSyslogMaxHosts.0

<1 - 10>

;commit

The default setting for wfSyslogMaxHosts is five hosts. You can add to the

Syslog Host Table more entries than the configured maximum, but Syslog

forwards messages only to the first “n” active hosts, where n = the current

value of wfSyslogMaxHosts.

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 343 344

Brak uwag

Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 303