Avaya Using Technician Interface Software Instrukcja Użytkownika Pobierz pdf (Strona 258)

Using Technician Interface Software

B-2

308657-14.00 Rev 00

This section describes:

• The asynchronous terminal program available on UNIX and

remote PC workstations

• The Technician Interface

xmodem command, its parameters, and its options

• How you use the asynchronous terminal program and

xmodem commands

together in procedures for transferring files to and from Nortel Networks

routers

About xmodem

Nortel Networks routers support xmodem as a Technician Interface command

and a set of protocols for moving files between the Technician Interface console

port of a router and a remote workstation. The

xmodem command is based on the

Christensen protocol file transfer utility, V3.9, November 1990.

You determine the protocol for the task you need to perform by selecting the

appropriate syntax (parameters and options) for each

xmodem command. You

enter

xmodem commands directly at the command line prompt of either a UNIX

workstation or a PC workstation (run DOS utility). (The procedural information

you need to enter and use

xmodem commands follows on page B-3.)

As a set of protocols,

xmodem includes the:

• XMODEM/CRC protocol

• MODEM7 batch protocol

• XMODEM-1K block protocol

• YMODEM batch protocol

Of the four protocols available through

xmodem commands, you need to use only

the YMODEM batch protocol to transfer Nortel Networks files between a remote

workstation and a router. For this reason, this section covers information on the

YMODEM protocol only. (For information on the other protocols supported by

xmodem commands, see “For More Information,” later in this appendix.)

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 343 344

Brak uwag

Avaya Using Technician Interface Software Instrukcja Użytkownika Strona 258