Avaya BCM50 Przewodnik Konfiguracji Pobierz pdf (Strona 238)

100

101

238 Chapter 24 Dialing plans

NN40020-603NN40020-603

Provisioning for Call-by-Call limits with PRI

To program the system for Call-by-Call Limits with a PRI interface, you must:

• provision a DTM as PRI, if one is not already configured as part of the system

• select a protocol

• program incoming call routing

• program routes that use the PRI pools, see “Configuring call routing” on page 234.

Other required programming in the Element Manager

Programming Call-by-Call on PRI requires these settings:

• Select Configuration > Sets > All DNs to assign the line pool.

• Select Configuration > Telephony > Dialing Plan > Routing to assign a pool for routing,

and assign the service type and service id, if required.

• Select Configuration > Telephony > Dialing Plan > Loops > Call-by-Call Limits tab to

specify the minimum and maximum values for the pools.

Call-by-Call service routing

Table 41 is an example of a Routing Table containing Call-by-Call programming (available in the

North America market profile). Also refer to “Configuring Call-by-Call services” on page 235.

Table 41 Call-by-Call routing table example

Route Number

(000-999)

Dial Out

(24 digits)

Use Pool Service Type Service

Identifier

003 BlocA Public

004 BlocA FX xxxxx

005 BlocA TIE xxxxx

006 BlocB OUTWATS xxx

007 BlocB Private

008 BlocB Switched Digital

Note: The public DN lengths are used for all PRI calls except those whose routes use service type Private or service

type TIE with DN Type specified as Private.

Note: This type of routing applies only to those PRI trunks set with a

protocol of NI, DMS-100, DMS-250 or 4ESS.

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya BCM50 Przewodnik Konfiguracji Strona 238

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Avaya BCM50