Avaya Configuring MPOA Services Instrukcja Użytkownika Pobierz pdf (Strona 34)

Configuring MPOA and NHRP Services

2-4

309249-14.00 Rev 00

By default, when you enter and then exit the MPOA Service Record window, you

automatically create and enable the MPOA service record using the default

settings. You need only enter and exit this window one time to create and enable

the MPOA service record. However, for MPOA to operate, you must add at least

one MPS to the service record.

Adding an MPOA Server

You must add at least one MPS to any MPOA service that you create on an ATM

interface. Although not operational until fully configured, an MPS is enabled by

default when you add it to an MPOA service record.

A new MPS must be in the enabled state so that you can map it to one or more

LEC services. Then you can use either the BCC or Site Manager to map each

MPS to a specific LEC service on the router.

Using the BCC

To add an MPS, navigate to the desired MPOA service prompt and enter:

mps mps-name

<mps-name>

For example, on a System 5000 router, the following command adds an MPS

named “eastcoast” to an MPOA service:

mpoa-service/5/3/1#

mps mps-name eastcoast

mps/eastcoast#

7. Click on

Done

. You return to the Select Connection Type

window.

8. Click on

Done

. You return to the Configuration Manager

window.

Note:

You can have only one MPOA service record per ATM interface.

However, this service record can contain up to four MPSs.

Site Manager Procedure

(continued)

You do this System responds

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 147 148

Brak uwag

Avaya Configuring MPOA Services Instrukcja Użytkownika Strona 34