Avaya Configuring Frame Relay Services Instrukcja Użytkownika Pobierz pdf (Strona 45)

Frame Relay Overview

117376-A Rev. A 2-25

The router determines whether to route or bridge the packet, and then uses the

corresponding level of address. It uses routing-level addresses for routing trafﬁc,

and the MAC-level addresses for bridging trafﬁc.

Address-based distribution ensures that all outbound trafﬁc travels on the same

path, and that packets arrive in sequence. For protocols that cannot receive packets

out of sequence, use this method. Note, however, that this option does not always

distribute trafﬁc evenly across each line.

Protocol Prioritization and Multiline

You cannot use protocol prioritization with multiline. Protocol prioritization may

change the order of frames arriving over a multiline interface, and frame relay

multiline does not have the ability to correct the sequence.

Conﬁguring Synchronous Lines for Frame Relay

If you enable frame relay on a circuit, Site Manager automatically sets the

following synchronous line parameters (T

able 2-2):

For more information on these parameters, refer to Conﬁguring WAN Line

Services.

Table 2-2. Synchronous Line Parameters for Frame Relay

Parameter Value

BofL Disable

Promiscuous Enable

Service Transparent

WAN Protocol Frame Relay

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 93 94

Brak uwag

Avaya Configuring Frame Relay Services Instrukcja Użytkownika Strona 45