Avaya BCM 2.0 Networking Instrukcja Użytkownika Pobierz pdf (Strona 14)

14 Setting up Enterprise Edge Message Networking

Enterprise Edge 2.0 Message Networking Set Up and Operation Guide P0911952 Issue 02

8. In the Network Delay box, type a number from 1 to 60.

9. Click the OK button.

Network Site Table administration

Before local users can send messages to another site using Site-Based Addressing,

you must add the site to your local Network Site Table.

Adding a site to the Network Site Table

Before you add a site to the Network Site Table, you must create the following local

information about the target site:

Site Name

• The Site Name is a text name for the site that can be up to 16 characters. This

name is shown to local users when they address a message or review message

envelope information.

Host Name

• The Host Name is text name for the host site (Fully Qualified Domain Name)

that can be up to 128 characters.

Site Prefix

• The Site Prefix is a number between one to nine digits long that identifies the

site on the network. This number must be unique and not assigned to any other

site on the local system. Make the Site Prefix a number that is easy for users to

recognize and remember. The Site Prefix is usually the same as the sequence of

digits that local users dial to place a telephone call to the site. For example, if

local users dial 403-123-4567 to call someone at the target site, then 403123 is

an easily remembered Site Prefix.

• The Site Prefix cannot overlap any other Site Prefix in your Network Site Table.

For example, if you use Site Prefix 403123, it overlaps with prefixes 40312 and

4031234.

Next, you need to know the following information about the site, which can be

obtained from the Network Administrator for the target site:

Message Protocol

• The Message Protocol is the protocol used to send messages to the destination

site. The protocol depends on which type of Networking option your site has

installed. A choice appears only if both Enterprise Edge Message Networking

and Audio Messaging Interchange Specification (AMIS) are enabled on your

Enterprise Edge Voice Messaging system. If AMIS is not enabled, SMTP is

automatically chosen. For sites on a Digital Network the protocol is SMTP. The

default setting is AMIS.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Brak uwag

Avaya BCM 2.0 Networking Instrukcja Użytkownika Strona 14