
Configuring Dial Services
1-22 114062 Rev. B
Specifying the Authentication Protocol Information
For network security, the router must identify itself in the call setup message that
it sends to the remote router. The authentication protocols, CHAP and PAP, enable
the identification process. CHAP is the default protocol.
All lines in a pool must use the same authentication protocol.
To specify the CHAP information that the router uses when it calls a remote site:
1. Scroll down the PPP Demand Circuits window to the CHAP parameters.
2. Enter values for the CHAP Local Name and CHAP Secret parameters.
Each CHAP Local Name must be unique, but the CHAP Secret must be the
same for both sides of the connection.
3. Go to the next section, “Specifying the Connection Mode.”
Specifying the Connection Mode
The connection mode determines which router places a call first, which prevents
two routers from establishing a demand circuit with each other at the same time.
To configure the connection mode:
1. Scroll down the PPP Demand Circuits window to the Connection Mode
parameter.
2. Select a value for the Connection Mode parameter. Collision Master is
the default.
If this router is set to Collision Master, we recommend that you set the router
at the other side of the connection to Collision Slave.
3. Go to the next section, “Enabling a Protocol.”
Site Manager: CHAP Local Name parameter: page A-37
Site Manager: CHAP Secret parameter: page A-38
Site Manager: Connection Mode parameter: page A-28
Komentarze do niniejszej Instrukcji