Avaya Configuring Dial Services Instrukcja Użytkownika Strona 42

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 428
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 41
Configuring Dial Services
1-12 114062 Rev. B
Configuring PRI Lines
PRI lines are available only on the ASN, BCN, and BLN hardware platforms
using the following link modules:
Single or Dual Port Multichannel T1 Link Module (BLN and BCN)
Dual Port Multichannel T1 Net Module (ASN)
120-ohm Single Port MCE1-II Net Module (BLN and BCN)
120-ohm Single or Dual Port MCE1-II Link Module (ASN)
QMCT1 Link Module (BLN and BCN)
To configure PRI lines:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Click on an MCT1 or MCE1 connector.
Site Manager displays the Port Application window, which is similar to the
window shown in Figure
1-8.
3. Select PRI for the Port Application Mode and click on OK.
Site Manager displays the Clock Parameters window (Figure
1-9).
Figure 1-9. Clock Parameters Window
Site Manager: Port Application Mode parameter: page A-16
Przeglądanie stron 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 427 428

Komentarze do niniejszej Instrukcji

Brak uwag