Avaya SPEX Net Modules in ASN Platforms Instrukcja Użytkownika Pobierz pdf (Strona 38)

Installing SPEX Net Modules in ASN Platforms

2-4 115368-A Rev. A

Connecting Nodes That Use SPEX-HS Net Modules

Connecting Nodes with a Single SPEX-HS Cable

To connect nodes with a single SPEX-HS cable:

1. Insert the connector at one end of the SPEX-HS cable (Order No. 7166)

into the SPEX-HS Port A on the ASN at the bottom of the stack. Tighten

the thumbscrews.

The SPEX-HS Port C is reserved for future use.

2. Insert the next connector on the SPEX-HS cable into the SPEX-HS

Port A on the next ASN in the stack. Tighten the thumbscrews.

3. Repeat Step 2 for each node in the stack.

Figure 2-

3 shows four ASNs connected with a single SPEX-HS cable.

Caution: Before you can use an ASN with a SPEX-HS net module, your

router must be running Bay Networks Router Software Version 8.10 or later

(or BNX Software Version 5.00 or later), and diagnostic PROM (asndiag.exe)

Version 2.16 or later.

If your router is not running these minimum versions, it will fail diagnostics

and will not boot.

To upgrade your diagnostic PROM, use the Technician Interface

prom

command. (Refer to Using Technician Interface Software if you use router

software or Troubleshooting and Testing if you use BayStream software.)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Brak uwag

Avaya SPEX Net Modules in ASN Platforms Instrukcja Użytkownika Strona 38