Avaya SPEX Net Modules in ASN Platforms Instrukcja Użytkownika Pobierz pdf (Strona 35)

115368-A Rev. A 2-1

Chapter 2

Attaching Cables to SPEX and SPEX-HS

Net Modules

You can stack as many as four ASNs and use the SPEX or SPEX-HS net modules

to connect them so that they function as one logical router. Be sure to place the

nodes as close together as possible to allow for SPEX or SPEX-HS cabling.

The steps you follow to connect stacked nodes depend on whether you are using

SPEX or SPEX-HS net modules.

If the nodes in the stack contain SPEX net modules, proceed to the next section,

“Connecting Nodes

That Use SPEX Net Modules.”

If the nodes contain SPEX-HS net modules, go to “Connecting Nodes

That Use

SPEX-HS Net Modules.”

Note: If you just installed a SPEX net module, and you are not stacking

nodes, you must insert a SPEX terminator plug (Order No. 7140) in both the

IN and OUT ports of the net module. Do not use the SPEX cable to connect

the IN port to the OUT port. If you do not have terminator plugs, remove the

SPEX net module.

If the ASN contains a SPEX-HS net module, and you are not stacking nodes,

you must attach one of the connectors on the SPEX-HS cable (Order No.

7166) to Port A on the net module. If you do not have a SPEX-HS cable,

remove the SPEX-HS net module.

Note: An ASN with an SPEX net module cannot run in the same stack as an

ASN with a SPEX-HS net module.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Brak uwag

Avaya SPEX Net Modules in ASN Platforms Instrukcja Użytkownika Strona 35