Avaya Configuring BOOTP Services Instrukcja Użytkownika Pobierz pdf (Strona 27)

Starting SNMP, BootP, and DHCP Services

308644-15.1 Rev 00

1-7

Using Site Manager

To enable BootP on an interface, complete the following tasks:

Starting BootP/DHCP Relay

You can start BootP/DHCP relay using default values for all parameters. If you

decide to change some or all of the default values, see Chapter Chapter 5,

“Customizing BootP/DHCP Relay.”

Before you begin, you must verify that IP is configured on an interface, as

described in “Configuring IP for Global Protocols

” on page 1-2. You can also

enable IP, BootP, and BootP/DHCP on the router simultaneously.

You can use the BCC or Site Manager to enable BootP/DHCP relay on an

interface.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on the link or net module connector.

The Edit Connector window opens.

2. Choose

Edit Circuit

. The Circuit Definition window opens.

3. Choose

Protocols

. The Protocols menu opens.

4. Choose

Add/Delete

. The Select Protocols window opens.

5. Choose

BOOTP

and click on

6. Choose

File

. The File menu opens.

7. Choose

Exit

. You return to the Configuration Manager

window.

Note:

BootP and DHCP will not operate properly if the Broadcast Storms

feature is enabled. See Configuring Ethernet, FDDI, and Token Ring Services

for procedures to disable this feature, as necessary.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 195 196

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring BOOTP Services Instrukcja Użytkownika Strona 27

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Avaya Configuring BOOTP Services