Avaya Bay Command Console BCC Instrukcja Użytkownika Pobierz pdf (Strona 51)

Entering Commands and Using Command Files

303562-A Rev. 00

3-7

[

]

is any parameter-value pair you can optionally customize

for an object you specify in a BCC command line.

Using Default Syntax

Using default syntax, you do not need to enter the name of a required parameter;

you enter only its value at the proper location in the command line.

For example, the default syntax for configuring an Ethernet interface on an

AN/ANH, ARN, or BN router is:

ethernet

<slot>

The following commands are equivalent.

Using full syntax:

box#

ethernet slot 2 connector 1

ethernet/2/1#

Using default syntax:

box#

ethernet 2/1

ethernet/2/1#

Using Abbreviated Syntax

You can abbreviate BCC configuration commands as follows:

Example:

box#

eth 2/1

This command is the same as the following two commands:

box#

ethernet slot 2 connector 1

box#

ethernet 2/1

Note:

You cannot change the value of a parameter used by the BCC to create

an instance identifier. For example, you cannot modify the address value

assigned to an IP interface.To change the value of any required parameter, you

must delete the associated object, and then add it back into the device

configuration with new required values.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Brak uwag

Avaya Bay Command Console BCC Instrukcja Użytkownika Strona 51